Quote:
Originally Posted by nbb
Well, here is what I ended up doing after considering everyone’s input. I decided to back the rear axle tires (both sides at the same time) up on three levels of Lynx Levelers to take most of the weight off of the front axle. I then put a small floor jack under one side of the front the axle shackle (u-bolts) where it attaches to the leaf spring and jack the tire off of the ground just enough where it would spin freely. I only had to jack it up about an inch or less. Gave it a spin and 3 shots of grease. Let it down and did the other side of the front axle. Of course after that I put the tires for the front axles on the Lynx Leveler blocks and did the rear axles. Worked well and went really fast.
I called Lippert before I did this to see if they thought it was okay and they said it was. Said they just didn’t want you to lift the weight of the trailer while jacking on this position of the axle.
I tried to consider everyone’s input and be careful not to damage anything. I definitely recommend this procedure to minimize any risk to the axles. Get most of the weight off the axle before you jack it at the u-bolt.
Thanks again everyone!
|
Do you pull the trailer up on the levelers? Seems to me it would take 12 of the lynx levelers to get both sides up to level 3. I only have 10 unless I buy another set of 10. Doesn't the equalizer sort of defeat the purpose of raising the wheels on the axle with the levelers (i.e. leave a lot of weight on the opposite axle)?