Forum: Toy Hauler
04-29-2019, 09:57 AM
|
Replies: 14
Views: 3,091
Motor #1 and #2...unsure, as I had the same...
Motor #1 and #2...unsure, as I had the same question when I was working on mine. As part of troubleshooting, I had swapped the #1 and #2 wires around to be sure it was not the controller, which the...
|
Forum: Toy Hauler
04-20-2019, 07:31 PM
|
Replies: 14
Views: 3,091
Hey everyone. I profusely apologize for...
Hey everyone. I profusely apologize for disappearing into thin air. Tom is correct, I am retiring from the military after almost 24 years. In my haste to pack up and leave, I actually misplaced my...
|
Forum: Toy Hauler
04-10-2019, 01:35 PM
|
Replies: 14
Views: 3,091
As much as I did not want to have to push and...
As much as I did not want to have to push and wrestle the slide back out, I think you will be correct. The good motor I lifted out, I will need to push all the way back out to get it to drop in since...
|
Forum: Toy Hauler
04-10-2019, 09:57 AM
|
Replies: 14
Views: 3,091
Slide Motor Replacement
Good morning Schwintek Warriors,
Today is the day I roll out from southern MD on terminal leave. Extremely exciting. Rep chapter ahead.
Last night I pulled all the slides in except the bedroom...
|
Forum: Toy Hauler
04-01-2019, 09:54 AM
|
Replies: 5
Views: 1,431
|
Forum: Toy Hauler
03-31-2019, 01:15 PM
|
Replies: 5
Views: 1,431
I have Sailun and have been happy. I have had...
I have Sailun and have been happy. I have had them for five years now, though they have had very little use in the last two years.
When I replace them next, I may get them from etrailer.com, as...
|
Forum: Toy Hauler
10-13-2017, 10:09 AM
|
Replies: 20
Views: 9,828
|
Forum: Toy Hauler
10-13-2017, 10:02 AM
|
Replies: 17
Views: 4,143
|
Forum: Toy Hauler
10-08-2017, 10:34 PM
|
Replies: 20
Views: 9,828
My pin box was replaced last year. Only towed...
My pin box was replaced last year. Only towed once since then. But my 3950 had nearly 12k miles on it when I took it in for an extended warranty fix of the main slide. I went to grab some items...
|
Forum: Toy Hauler
10-08-2017, 10:22 PM
|
Replies: 17
Views: 4,143
|
Forum: Toy Hauler
07-30-2017, 08:16 PM
|
Replies: 3
Views: 2,213
Recalls
Good web site, pulled off of FB.
There are already recalls for the 2018 Voltages.
Several years of not installing some clamp correctly. You would have thought they figured it out by now.... ...
|
Forum: Toy Hauler
07-30-2017, 09:13 AM
|
Replies: 7
Views: 1,541
|
Forum: Toy Hauler
07-30-2017, 09:12 AM
|
Replies: 7
Views: 1,541
|
Forum: Toy Hauler
07-24-2017, 10:07 AM
|
Replies: 27
Views: 10,228
|
Forum: Toy Hauler
07-22-2017, 12:02 PM
|
Replies: 5
Views: 1,585
Also, looking at the whichagizit on your...
Also, looking at the whichagizit on your capacitor, I think the instructions speak specifically about that if you have one installed. It has been quite sometime now, but I will do some digging.
...
|
Forum: Toy Hauler
07-22-2017, 12:00 PM
|
Replies: 5
Views: 1,585
|
Forum: Toy Hauler
07-21-2017, 12:49 AM
|
Replies: 12
Views: 3,470
I have Xtraride also and am happy with them. I...
I have Xtraride also and am happy with them. I had my hitch replaced and the living room slide mechanism replaced for $100. The cost on the slide was nearly $4k, while the hitch was right at $1200....
|
Forum: Toy Hauler
07-19-2017, 09:33 AM
|
Replies: 10
Views: 3,094
|
Forum: Toy Hauler
07-18-2017, 09:54 AM
|
Replies: 24
Views: 6,772
Unless you have tire inflation charts for a...
Unless you have tire inflation charts for a particular tire, you should run them at sidewall pressures, anything less is asking for trouble. Running tires with less pressure and a lot of weight will...
|
Forum: Toy Hauler
07-16-2017, 10:52 PM
|
Replies: 17
Views: 4,374
Here is my extra vent and you can see the air...
Here is my extra vent and you can see the air return that has been enlarged.
I had to put it on the couch side of the trailer, as the stove side has that thing attached to the ceiling.
This...
|
Forum: Toy Hauler
07-16-2017, 10:41 PM
|
Replies: 17
Views: 4,374
|
Forum: Toy Hauler
07-16-2017, 01:05 PM
|
Replies: 17
Views: 4,374
|
Forum: Toy Hauler
07-15-2017, 06:56 PM
|
Replies: 10
Views: 3,094
|
Forum: Toy Hauler
07-15-2017, 05:49 PM
|
Replies: 17
Views: 4,374
Have to remove it from the roof side. The lag...
Have to remove it from the roof side. The lag bolts are probably less than adequate, due to the clowns at the manufacture over tightening them. I went up one size and all is right with the world now....
|
Forum: Toy Hauler
07-15-2017, 10:58 AM
|
Replies: 10
Views: 3,094
|