Hello all I have a 2014 voltage, the main slide is having issues with one of the motors. I leave this weekend for a week. Will it be ok to run slide using overide to open and close for the couple times needed until I can get home and try to replace the motor? Thank you
Brandon
__________________
__________________
2014 Voltage V3605
2021 Ram 3500 CCLB DRW
Brandon, you should be fine if doing that works, if you have a motor going bad the override may not work. Have you tried the override? What is the motor doing/how is it acting? May want to call a mobile/Schwintec service tech for more info.
I had to replace a motor once also a slide controller.
Its showing a short on the controller. So I may just have a wire that came undone as well. The motor appears to have gotten wet at some point as it is rusted. The override does bring the slide completely in and out without any issues. I will attempt to change it myself when I get back. Or at least take it out to see if a wire is corroded or if the motor is just bad. Thank you for the reply.
__________________
2014 Voltage V3605
2021 Ram 3500 CCLB DRW
Most times the motor is ok. It’s the circuit board mounted on top of the motor that keeps the motors synced that goes bad. Unfortunately you can’t buy the circuit separate. I think over ride bypasses the circuit but the slide may get out of sync some.