Originally Posted by HossDodge
I just installed a Furrion backup/observation camera. The camera fits in the housing already on the camper. It syncs perfectly with the monitor. The problem is, the pre-wire is constantly hot - the camera stays on. It stays on whether plugged up to the truck, House, or just the battery.
Does anyone have a schematic showing where the pre-wire is connected to source power, so I can put a switch inline to turn the camera off when not needed?
Itís on a new, 2018 Voltage 3605.
2014 3905 and mine is on constant as well. I cannot tell where it is connected as the wiring on mine goes right into a hole in the roof. Schematic unfortunately isn't going to happen. I have considered cutting a round hole in the ceiling in the garage in order to try to figure out a switch but and use a cover like you see below your mixing valve in the shower, but just haven't gotten around to it.
2014-3950, Full Paint, 17.5" tires, 370W solar, 3100W Magnum inverter w/ AGS, 7500w diesel generator, Micro-Air Easy Start 364 (x3)
2019 Ram 3500 Limited w/ Max Tow pkg