Denali 293RKS RHS slide out
Hi All,
I have a 2013 Denali 293RKS 5th wheel. While doing some routine cleaning I found that I could see light between the outer edge of the right side slideout floor and the exterior wall. Closer inspection under the slide out revealed that most of the screws in the aluminum angle that attached the floor to the wall had backed out and were lost. This resulted in the exterior wall of the slide out dropping almost an inch and pulled away from the floor. The hardware used to attach the aluminum angle to the exterior wall are #8 countersunk head wood screws. I replaced them with #10 pan head wood screws and doubled the screw pitch by adding additional screws mid way between the existing screw holes.
Just curious if anyone else has had a similar experience with the floor to wall hardware backing out and the wall dropping.
Thanks very much for your feedback.
Tom
__________________
__________________
T & J
2013 Denali 293RKS
2016 F250 6.7L CC 4X4 SRW
|