On my 2003 Dutchman Lite 26qb, near the water pump are these 2 pull pins. Can I assume that these are ByPass valves, and this is how I bypass the Hot Water tank for when I want to winterize the unit?
Due to how the HW tank is installed, I cant actually see the back of the tank. These pull pins are next to the Water Pump, and about 3' from tank.
If not, then does anybody know If and Where the HW by pass is?
__________________
__________________
2003 Wildwood 38FKDS Park Model
2003 Dutchman 26QB
That looks more like some type of low point drain setup. ARe there two pipes sticking out from the bottom of the trailer that correspond to the two blue pipes going down through the floor?
HW bypass looks like this.
__________________
__________________
2012 Aspen Trail 2710BH | 470 watts of solar on the roof | 2x6V GC batteries | 1500 watt PSW inverter | Micro Air on A/C | so far strictly boondocking
There is a panel right under the oven, and I noticed that the panel is right about where the HWT would be. Pulled out the 4 screws and There It Is, the back side of the HWT. And, there is where I found the bypass valve. Thanks for the info provided. And yes, the 2 pull rings I pictured are Low Point drains.
__________________
2003 Wildwood 38FKDS Park Model
2003 Dutchman 26QB