I'm looking to add the remote system to my 5er. It looks like there are several outputs with pos and neg terminals. I assume it reverses polarity of the motors to make them go both directions. However, with the schwintek slides, you can't wire the linc board directly to the motors. Have any of you looked at yours to see how their wired? Do the pos and neg on the board wire straight to the ext and ret on the schwintek controller?
Sorry no one could help. I too have asked questions in the past about adding functions to the Link remote system, but it seems no one really knows much about it. Please post what you find out from them.
Sorry no one could help. I too have asked questions in the past about adding functions to the Link remote system, but it seems no one really knows much about it. Please post what you find out from them.
Sinecure, I talked to lippert and the tech said pos and neg from receiver wired to Ext and ret on the schwintek controller. I hope he knows what he's talkin about. I guess I'll know when I try it. By the way, do you know where your receiver is located? I'm thinkin about locating mine behind my control panel since most of the wires I need are there.
Our link remote receiver is mounted in the garage on the passenger side up above the vacuum cleaner box.
__________________
2015 Voltage 3970, EPIC IV, Full Body Paint, Loaded
2015 Ram 3500 long bed, diesel, DRW, Air Bags, aux fuel tank
2012 Polaris Ranger Crew 800 EPS
2015 Polaris Ranger 900 EPS