We have been cleaning up the inside of our new rig and running the furnace. It works pretty good. The issue I have is with the limitation of only going down to 60 which we both find too hot if you are working in there. Has anybody either tweaked or replaced the thermostat that lets you set it lower, say 50? I contacted the manufacturer and they said 60-86 and that is it.
Don't know where my post went so I'll try again. We use the Hunter 42999B which has a range of 45-95. It's digital (non-programmable) and has both heat and cool settings. For the user manual... http://www.hunterfan.com/uploadedFil...als/42999b.pdf
OK, my previous post(s) need moderator approval due to the link I included. Until then I'll just post the make/model we use which is a Hunter 42999B which has a range of 45-95, digital (non-programmable) and heat & cool settings.